Tuesday, September 17, 2013

A round box



Today I discovered that round packaging is hard to duplicate, however not impossible. Because of its round nature there were three separate pieces to work with, rather that one large one. I think this actually gave me an advantage when laying everything out. I could lay the pieces out separately, and piece them together, as well as look at everything from an upright position when it was time to design the elements. I could focus on the pieces one at a time, and combine them when I was ready.

The hardest part of this particular package was the curved piece that attaches to the lid. I think our math was correct when trying to determine the curve, but printing it out and assembling it will be the only way to know for sure. For some reason, the small notches in the bottom piece gave me some trouble, but I think that was user error aside from actually being difficult.

Designing the pieces proved to not be too difficult. Just some measuring, colouring and font picking. Once printed I will be able to tweak the pieces to make sure they are correct. On that note...

Next Step: Print and assemble. Wish me luck!

No comments:

Post a Comment